The Seiko MP-B20 is a mobile printer that allows you to print receipts directly at the table when checking out your guests. The following steps will guide you on how to connect the Seiko MP-B20 to your Lightspeed POS system.

What you'll need

Before you can set up your printer, you’ll need the following hardware included in your shipment:

Inserting paper roll

1. Press the paper cover button to open the paper cover.
2. Set the thermal paper into the paper holder with its printing surface facing the thermal head. If the paper is set in the wrong direction, the printer will not print.
3. Pull the thermal paper straight out until the tip of the thermal paper extends over 2 inches from the paper outlet. Make sure that the thermal paper does not slant.
4. Push the center of the paper cover firmly to close the paper cover.

Connecting the printer to the POS system

After the physical setup of the printer, follow the steps below to connect the printer with the POS system.
Your iPad should already be connected to your POS network (via Wi-Fi or LAN). If not, we recommend that you read the article Changing network settings.

1. Set up a corresponding printer in your Lightspeed Back Office and assign the driver Seiko Mobile2* Bluetooth to it.
2. Open Settings on your POS device.
3. Tab Bluetooth on the navigation bar.
4. Turn off the printer if it is already on.
5. To bring the printer in pairing mode, press and hold the power button for about 7 seconds until the power LED blinks quickly.
6. On the iOS device in the Bluetooth section, tap on the printer from the list of available devices to connect the printer and device.
7. Create a test order to send data from the POS device, and verify that the data is printed correctly.